Here I show You a small guide as I modified my graphic card, with a titan graphic card cooler and ramsinks. In every good Shop gives the accessories.

Here one sees the card in the original state with a passive cooler.

I loosened the cooler, it left easily I needed no tools. As one can still see, at the bright places, the radiator did not cover not at all the whole GPU, but stuck only to the edge. What would result in the consequence a bad dissipation of heat.

Here I distributed the Heat-Conducting Glue(HCG). Importantly is, that the HCG is not distributed out the GPU and should cover it too only easily.

The same one is valid also for the RAM. One should place special attention onto the soldering tab, they are very densely at the RAM. A small drop is enough. One should not let itself with the workmanship to too much time, as a rule 3 - 5 min.

Here I put on the active cooler and a RAM cooler. The cord is from the AGP - to place slot away since one could wedge it in else.

You should attention to transistors. The by seat of the cooler could damage. As one sees below, the transistor prevents that draw up the cooler axial. Here must find a medium size, between functionality and appearance.

Here all cooler are attached. Now one burdens for 20 - 30 min. where the adhesive must harden. To fix the cooler you should put some objects upon them. But take care not to destroy the RAM modules.It is recommend to put a cup upon the CPU-Cooler. Beside the VGA-Card put a book (height: ramsinks). Then put another book upon the RAM coolers to fasten the memory cooler.However, does not ask any 1000 sided novel :-).

I hope you like my small guide. A lot of fun.